Every chart looks like a mess of candles until you give it a map. This is the map I use. I split the chart into big blocks of 1,000 pips, then split each block into four 250-pip quarters. The quarters give me clear levels to aim for, so I always know where the next target is and where I should be careful. This is my own method, explained as simply as I can.

→ The map: one 1,000-pip range, four 250-pip quarters, five levels

Step 1: Find the 1,000-pip range

A pip is the smallest standard step in a forex price. On most pairs, including GBPUSD, one pip is 0.0001. So 1,000 pips is 0.1000, which is exactly one round-number block, such as 1.30 to 1.40.

Price is always sitting inside one of these blocks. Right now GBPUSD is in the block from 1.30 to 1.40. If it ever breaks out above 1.40, it moves into the next block, 1.40 to 1.50. If it falls below 1.30, it moves into 1.20 to 1.30.

Step 2: Cut the range into four quarters

250 pips is 0.0250. So the 1.30 to 1.40 range gives us five levels:

LevelWhat it is
1.4000Top of the range
1.3750Upper quarter line
1.3500Middle of the range
1.3250Lower quarter line
1.3000Bottom of the range

That gives four quarters: 1.30 to 1.325, 1.325 to 1.35, 1.35 to 1.375 and 1.375 to 1.40. Each quarter is 250 pips tall. Draw these five lines on your chart once and you can leave them there.

Step 3: Use the quarter lines as your targets

The quarter lines are not entry signals on their own. They are a guide for where price may travel to next, and so where I plan to hold a trade to. I only use them after the macro and the chart agree on a direction.

Here is my example. Say the dollar is bullish on both sides:

If GBPUSD is trading at 1.325 or lower, I am looking at holding my shorts down to 1.30, which is the next quarter line. When price gets near 1.30 I decide what to do: take the profit, or move my stop and give it room, if the bias still supports it. If it breaks below 1.30, GBPUSD has left this block and a new map starts at 1.30 to 1.20.

The same idea works the other way around. If the dollar is bearish on both sides and GBPUSD is above 1.35, I look at holding longs up toward 1.375, then 1.40.

A worked example

In our GBPUSD short trade idea, price was in the second quarter, between 1.325 and 1.35. A short from there has the 1.325 line as the first natural target and 1.30 as the next one. That is why the target in that post was set well below the entry instead of a few pips away. The stop sat above 1.35, the middle of the range, where the idea would be wrong.

Why this helps

  1. It gives targets a reason. You are not picking a take profit out of thin air. You are using a level the whole chart is built around.
  2. It keeps you patient. If the bias is right, you know the trade has about 250 pips to run to the next line, so you are less likely to close it early out of nerves.
  3. It stops you chasing. Entering a short right on a quarter line at the bottom of the range leaves little room. The map shows you when there is not much space left.
  4. It works on any timeframe. You draw it once on the daily chart and use the same lines on the lower timeframes.

What to watch out for

The risks